Move the cursor over the desired area of the image to find out about that part of the Scratchbox
Channel 3 fader
This fader is used to set the volume of channel 3 in the mix when the channel 3 routing switch is set to MIX.
Channel 1 fader
This fader is used to set the volume of channel 1 in the mix (along with the crossfader).
Channel 2 fader
This fader is used to set the volume of channel 2 in the mix (along with the crossfader).
Channel 1 cutswitch
This switch allows the sound of channel 1 to but cut.
Channel 2 cutswitch
This switch allows the sound of channel 2 to but cut.
Crossfader
The crossfader is used to fade between channel 1 and 2.
Session/Aux input level
Set the Session/Aux input level with this potentiometer.
Channel 3 input select
Select between the MIC and LINE input for channel 3.
Channel 3 0db led
0db level indicator for channel 3.
Channel 3 input level
Set the channel 3 input level with this potentiometer.
Channel 3 tone control
High and Low tone controls for channel 3.
Channel 3 PFL select
Send the signal of channel 3 to the headphones.
Channel 3 routing switch
This switch allows you to send the signal of channel 3 to channels 1 and 2.
Ch 1 - Ch 2 PFL fader
When the signal of channels 1&2 is sent to the headphones this fader sets the relative monitoring level of each channel.
Channel 1 input select
Select between the PHONO and LINE input for channel 1
Channel 2 input select
Select between the PHONO and LINE input for channel 2
Channel 1 input level
Set the channel 1 input level with this potentiometer.
Channel 2 input level
Set the channel 2 input level with this potentiometer.
Channel 1 equalizer
3 band equalizer for channel 1.
Channel 2 equalizer
3 band equalizer for channel 2.
Channel 1 FX switch
Press this switch to send the signal of channel 1 to the external effects.
Channel 2 FX switch
Press this switch to send the signal of channel 2 to the external effects.
Channel 1 balance
Left/right balance fader for channel 1.
Channel 2 balance
Left/right balance fader for channel 2.
FX wet/dry fader
This fader sets the amount of signal that is sent to the external effects from none (DRY) to all (WET).
Channel 1&2 routing
With this switch channels 1 and 2 can be swapped.
VU-meter
For monitoring levels.
VU-meter mode
When pressed, the VU-meter will show the level of channel 1 on the left half of the VU-meter and that of channel 2 on the right. When not pressed the VU-meter will show the level of the mix.
PFL mix switch
To send the mixed signal to the headphones.
Master 1 output level
Set the Master 1 output level with this knob.
Master 2 output level
Set the Master 1 output level with this knob.
Mono mode switch
Switch between mono and stereo operation of the scratchbox.
PFL CH 1-2 switch
Send the signals of channels 1&2 to the headphones.
